Articles on: X-DRAW

I have updated the BOM but Signal Flow Diagram is not updating

If the Signal Flow Diagram is not updating in XTEN-AV after you update the BOM, it usually happens because the Line Schematics are not updated properly.


Kindly follow the steps below to update the Line Schematics:


  • Add, remove, or update the product in the BOM as required.



  • If your making changes to the existing product, kindly select the Re-draw Device option and then click on Add Product to update the changes.



  • Then open the Line Schematics in the X-DRAW Editor and click on the Pull BOM Changes option to update the diagram with the latest BOM modifications.


Note: Once the updated device starts reflecting in the Line Schematics, you will need to re-create the connections.



  • After creating the connections, click on the Unsaved Changes. Click here to save button to save the changes.



  • Then open the View Docs page and hover over the Automated Signal Flow Diagram tile. Click on the three-dot (⋮) menu, and select the Re-Generate option to update the changes in the Signal Flow Diagram.



  • A confirmation pop-up window will appear. Click on Regenerate to proceed.



  • It will take some time to regenerate. Once the process is complete, the updated Signal Flow Diagram will open in the X-DRAW Editor.




Updated on: 09/15/2026

Was this article helpful?

Share your feedback

Cancel

Thank you!