Articles on: X-DRAW Editor

How to Regenerate the Signal Flow Diagram?

Overview:


In X-DRAW, you can regenerate the Signal Flow Diagram in two different ways. You can either regenerate it directly from the X-DRAW editor or regenerate it from the Design Documents section.


Method 1: Regenerate the Signal Flow Diagram from Design Documents.


  • Open your project and navigate to the Design Documents section and locate the Signal Flow Diagram document card.



  • Click the three-dot menu (⋯) on the document card. Select Re-Generate from the dropdown menu.



  • After clicking Regenerate, a pop-up message will appear stating that all current changes will be discarded and the diagram will be regenerated from scratch. Click Regenerate to proceed.



  • Once you click Regenerate, you will be redirected to the X-DRAW editor, where you can view the updated products in the Signal Flow Diagram.



Method 2: Regenerate the Signal Flow Diagram from the X-DRAW Editor


  • Open your project in XTEN-AV and open the Signal Flow Diagram in the X-DRAW editor.




  • In the X-DRAW editor, locate the Draw with AI Beta option in the top menu and click Regenerate to regenerate the diagram.




  • After clicking Regenerate, a pop-up message will appear stating that all current changes will be discarded and the diagram will be regenerated from scratch. Click Regenerate to proceed.




Updated on: 11/09/2026

Was this article helpful?

Share your feedback

Cancel

Thank you!