Default Paper Size and Limit Drawing Area

To set the default paper size and page orientation for your X-DRAW Editor, please follow the steps below:

Settings

- Click on the 'Settings' option located in the top-right profile area.

- Navigate to the 'X-DRAW settings' tab, and select the 'Paper Size Settings' option.



Paper Size and Limit Drawing Area Setting

- In the 'Paper Size Settings' section, you can set the default paper size and page orientation for your X-DRAW Editor.

- To freeze your page size, use the 'Limit Drawing Area' option.



Change Paper Size in the X-DRAW Editor

- You can also select the desired Paper Size directly from the X-DRAW Editor interface.



Using the Limit Drawing Area Feature in X-DRAW Editor

- To freeze your current selection of the page, click on the 'Limit Drawing Area' option from the right side of your editor. This will prevent you from moving the product outside the page boundaries.



- If you wish to move your product to another page, simply uncheck the 'Limit Drawing Area' option.



Note: These settings will only affect new drawings (Line Schematics, Signal Flow Diagram, Rack Layout, Floor Design Plan, Floor Project Plan) created in every flow (X-DRAW, Questionnaire). Existing drawings will remain unchanged. The settings will apply to new tabs and new drawings.

Updated on: 07/16/2024