> ## Knowledge Base Index
> Fetch the complete knowledge base index at: https://knowledgebase.xtenav.com/sitemap.xml
> Use this file to discover available pages before exploring further.
> Pure-Markdown content can be obtained by appending a '.md' suffix to the content URLs listed in the sitemap (without the trailing slash).

# Default Paper Size and Limit Drawing Area

To set the default paper size and page orientation for your X-DRAW Editor, please follow the steps below:

* Click on the **'Settings'** option located in the top-right profile area. Navigate to the **'X-DRAW settings'** tab, and select the **'Paper Size and Block Settings'** option.

![](https://storage.crisp.chat/users/helpdesk/website/-/e/3/c/d/e3cdae6433963000/only-setting_15f9mf0.png)

**Paper Size and Block Setting**

* In the **'Paper Size Settings'** section, you can set the default paper size and page orientation for your X-DRAW Editor. To freeze your page size, use the **Limit Drawing Area** option. Click on the **Save** button.

**Note:** These settings will only affect new drawings (Line Schematics, Signal Flow Diagram, Rack Layout, Floor Design Plan, Floor Project Plan) created in every flow (X-DRAW, Questionnaire). Existing drawings will remain unchanged. The settings will apply to new tabs and new drawings.

![](https://storage.crisp.chat/users/helpdesk/website/-/e/3/c/d/e3cdae6433963000/image_1ky2f4b.png)

**Change Paper Size in the X-DRAW Editor**

* You can also select the desired **Paper Size** directly from the X-DRAW Editor interface.

![](https://storage.crisp.chat/users/helpdesk/website/-/e/3/c/d/e3cdae6433963000/image_oe2ji1.png)

**Using the Limit Drawing Area Feature in X-DRAW Editor**

* To freeze your current selection of the page, click on the **'Limit Drawing Area'** option from the right side of your editor. This will prevent you from moving the product outside the page boundaries.

![](https://storage.crisp.chat/users/helpdesk/website/-/e/3/c/d/e3cdae6433963000/image_12jbobh.png)

* If you wish to move your product to another page, simply uncheck the **'Limit Drawing Area'** option.

![](https://storage.crisp.chat/users/helpdesk/website/-/e/3/c/d/e3cdae6433963000/image_1bhxavq.png)
### Related Article

* [How can I resize my entire drawing to fit the page size?](https://knowledgebase.xtenav.com/en-us/article/how-can-i-resize-my-entire-drawing-to-fit-the-page-size-1b656e4/?utm_source=chatgpt.com)
* [How can I change my schematic to a landscape orientation?](https://knowledgebase.xtenav.com/en-us/article/how-can-i-change-my-schematic-to-a-landscape-orientation-kar5vq/?utm_source=chatgpt.com)